If you are planning to install a new bamboo flooring in your house and have no intention of paying someone to do the installation, you should make sure you have all the tools to do the job well done. Here is a list of basic needs to have at hand. Writing this list and check them out, as part of the toolbox.
Circular Saw - This is the circular saw used to cut the panels plans.
Screwdriver - to remove and tightenscrews.
Drill and bits - This is for starter holes with nails and screws. When using a screwdriver in his hand is too long can also get a small screwdriver attachments for exercise.
Hammer - nail in general.
Prybars - To remove the damaged parts, but also used to hold the final table in a position to nail.
Butt Chisel - Great for removing wall baseboards.
Putty Knife - Useful if you need to use woodmastic or adhesive.
Punch - This is a small point in the final. He plays with a hammer to drive the point deeper than the surface of the wood. Then fill the holes and paint or stain to match. Sometimes they remain open if it is an intentional part of the project.
Tape Measure - To measure the length of rooms, tables, anything. Essential in the initial design, are also useful when cutting boards to ensure they are of sufficient length. Remember measure twice, cutonce.
Chalk line or laser line - marks the line where you work or alignment tables. A chalk line is in part a chalk line of truth. If you do not want the mess that can be upgraded to a line that launches a laser beam along its chosen path.
Carpenter's Square - this is for general use to ensure that the edges are square and aligned with each other. Useful for the initial design.
Posts
No comments:
Post a Comment